DCC & DC

The Bachmann 16V DC Multi-Accessory Power Supply allows you to power up to six powered accessories up to a one-amp load (instruction included with most accessories tell how much current they use in milliamps). Connect as many as three accessories such as...

This control provides the simplest way to wire and control tricky reverse loops, wyes, and turntables. It has reversing switches for two mainline cabs plus a switch, selectable by either cab, for directional control on reversing loops, and so on. Cab...

A handy small electrical hookup conector designed for tight spaces. For #18-22 wire and #3 screw post. Maximum width is .218" (24 pieces per pkg.) Atlas Spade Connectors #3 (24)

Breakout board for the Digitrax PM42 board The PM42 breakout board is setup to accept up to 2 inputs and 4 distinct outputs. Each output can be configured with jumpers to make it a reversing section. The board comes with one set of jumpers that allows...

The single input breakout board for the BDL168 block detection eliminates soldering connections to the card edge or card edge adapter of this product. This design has a single input, meaning all 4 detection zones (and all 16 sections) are connected to a...

The multiple input breakout board for the BDL168 block detection eliminates soldering connections to the card edge or card edge adapter of this product. This design has 4 inputs separate inputs, each tied to a specific detection zone; each zone has 4...

Note: designed for use with Tortoise(TM) switch machines manufactured before May/June 2020 that feature a tan 1-19/64" (33mm) wide PC board. See ACL10001 for updated version SNAPS! is a new product that we have developed and manufactured in-house here at...

 Note: designed for use with Tortoise(TM) switch machines manufactured before May/June 2020 that feature a tan 1-19/64" (33mm) wide PC board. See ACL10001 for updated version SNAPS! is a new product that we have developed and manufactured in-house...

Note: designed for use with Tortoise(TM) switch machines manufactured before May/June 2020 that feature a tan 1-19/64" (33mm) wide PC board. See ACL10001 for updated version SNAPS! is a new product that we have developed and manufactured in-house here at...

This edge connector fits the Tortoise switch machine and features factory-installed shims for a snug fit. See images for picture of the older machines. They are tan. See ACL10000 for newer produced switch machines