N Scale

Fence leans to the side about 9 degrees from vertical for the falling over look. Include 6 - 24 scale feet long 6 foot high panels and all are different as to ageing and sections cut out.

Contains laser cut laser board parts to build one four story fire escape. This includes three landings and two sets of stairs plus a ground floor ladder. These have been tested and fit well on DPM Buildings.

A sheet includes 8 wheels at 48” and 54" in diameter and 8 wheels at 66” and 72" In diameter.

These are the perfect starter kit for your fist wood kit. The kit includes 6 laser cut picnic tables and 3 pages of directions with color photos. There are only nine parts per table so it's a good evening project. Picnic tables like these can be used...

Stair case with hand rails 3 per kit includes a assembly jig. Designed so they can go in any direction from building.

Delivery wagons based on drawing and Photos of wagons used from the 1850’s till the early 1900’s. Kit contains parts for Two wagons cut from laser board and micro plywood.

Note the frame on back side. All laser cut, all you need to do is glue the frame on and set on your layout. This fence has 144 scale ft and no gate.

Stair kit has 12 stringers, 80 treads and an assembly jig.

Kit contains 3 Farm Wagons.

The kit has parts to make one flat car or gondola. The price is less trucks and couplers. It takes Micro trains trucks with short extension couplers.

Patterned after many of the home made cars found on logging line and branch line around the country. They had a small shack built on a flat car for storage and were even used as freight cars for small loads. Kit is light ply and laserboard construction...

All wood kit priced less trucks and couplers. Takes Micro trains trucks with short extension couplers.

The kit has parts to make one flat car or gondola. The price is less trucks and couplers. It takes Micro trains trucks with short extension couplers.

Kit contains 6 - 80 Foot Span Trusses with a 4/12 Slope.

Kit contains 10 - 50 Foot Span Trusses with a 4/12 Slope.

N Scale T-trak bridge drop module the measures 12 1/8 by 14 inches with a 2 in drop in the center. The bridge module is set up for using the Kato 20-40 or 20-45 sections on the ends and either the Kato 20-010 186mm track section or the bridge in the...

Simple to build and lightwieght, these are the ideal module to get started in T-Track or model railroading in general. Made from 1/8th" plywood with tab and slot construction, the only tool needed to build is a small hammer. These are the 12 1/8" x 12...

Simple to build and lightwieght, these are the ideal module to get started in T-Track or model railroading in general. Made from 1/8th" plywood with tab and slot construction, the only tool needed to build is a small hammer. These are the 12 1/8" x 12...

A small branch-line engine house or car shed. Will fit a GP-38 or 50 ft cars. Or use a as a heavy equipment repair building. Our weathered printed paper siding is supplied as shown. Foot print f 3 x 5 inches