Electronics

This adapter mates with the above two power supplies to make them easy to hook up to wires using the screw terminals. Jack size is 5.5/2.1 mm. Plus and minus terminals are marked. Price is for one adapter - picture shows two to illustrate both ends.

1/4" wide x 36 yd. roll of Kapton tape.

This M1 decoder (see M1 for more information) comes connected to a 3.5" (8.89 cm) long harness which is terminated with a 8-Pin NMRA plug rotated 90 degrees from the standard orientation. This allows the decoder to accommodate the UK's narrow gauge...

The Analog Filter 1 (AF1) is used to filter the DC signal leaving the power pack. This filter pack corrects flickering in lighting effects and low-speed auto-reversing. Only one AF1 is required to smooth out the operation of all of the locomotives being...

This product is used with the LT-50 "Layout Throttle." This panel can be used to create a DCC track output when used with an LT-50 using the specified jack. A single additional wired LCC throttle can be connected to the front of the panel, and this...

Each card contains 50' of 5 conductor stranded ribbon wire that can be used with any scale Atlas switch machines. Also can be used as layout wire.

The Mobile Control Pro is ESU's latest answer to the question of how to combine the advantages of smartphone technology with the needs of model railway control. The Mobile Control Pro is essentially a compact Android-based tablet equipped with controls...

The ESU PowerPack Midi can be wired to all fifth generation ESU decoders (LokSound 5, LokPilot 5, LokPilot 5 Basic). It reliably supplies energy to your locomotive when traversing dirty track or long turnout ladders. With its energy storage (6x1 Farad...

The LokPilot 5 Fx micro and its "twin" LokPilot 5 Fx micro DCC are versatile decoders with a Next18 interface on a footprint of 13.0mm x 9.2mm. They are used in all vehicles of nominal sizes N to H0, which do not have an engine output, but should...

Speakers for model trains

Speakers for model trains

Speakers for model trains

Speakers for model trains

Speakers for model trains

Speakers for model trains

A 1 foot (12in) length of CAT6a cable. Useable in different applications such as connecting systems or DCC systems to computers.

Servo Extension Cable (M-F) This 39" cable may be used to extend the length of the above (M-M) cables.

USB to serial Interface unit. Includes driver disk.  Well suited for interfacing NCE Power Pro command station to USB. This unit does not require any modifications to the command station for proper attachment.  Note: Not for Power Cab,...

Octopus IIIBoard has 8 positions for driving servos between two positions and 8 inputs for fascia controllers (see below) or toggle switches.  Octopus III uses the remote board (below) to align the servos and has automated endpoint adjustment as...

SPDT Snap Switch for Miniature Servo Bracket   Snap Switch mounts on the back of the bracket with the 2 included screws and some thick CA glue. Provides a set of contacts for controlling frog power  or signaling. Switches near dead center...