DCC Accessories

The GSH-KR1 is designed for long-term reliability by incorporating cell-balancing circuitry, which helps protect each capacitor from over voltage and premature failure. Unlike basic capacitor packs,...

What you need to know about Version 3: ► Older version 1.x wireless radio cabs (v1.4x/v1.5x/v1.7x) can be upgraded to V3. A new wireless board will need to be installed for $106+ shipping► RB02 base...

Changes direction when the Opto-Sensor is covered. Use for test track, window display, mine train or automatic reverse loop operation. Pushbuttons can be connected for manual reversing. Requires 12V...

5 Amp booster compatible with most NCE DCC systems. Track voltage is adjustable from 10 to 16.5 volts. Factory set to 14V. P519 power supply is now included. Not recommended for use with the Power...

Convenient pre-made, pre-tested cables, ready to use on your layout. LocoNet Wiring is a snap with these cables

Convenient pre-made, pre-tested cables, ready to use on your layout. LocoNet Wiring is a snap with these cables

Use with crimper tool to make custom length LocoNet cables & replace broken plugs.

Don’t let dirty track or brief power interruptions ruin your operation. The all-new CurrentKeeperIII is our most compact solution yet—designed to keep your locomotive running smoothly through...

The new ESU PowerPack Maxi has been developed as the powerful complement to the LokSound L V4.0 /  LokSound  5 L decoder. It can, of course, provided there is sufficient space, also be connected to...

Using this adapter board with the dimensions 13.5mm x 8.4mm, Minitrix® locomotives with MTC14 interface can finally be equipped with a LokSound decoder at your own discretion: The adapter board is...

This adapter board with the dimensions 54.0mm x 17.0mm has an ESU PowerPack ‘On Board’. Although the capacitors protruding at the front and rear make for a total length of 70mm, this adapter board is...

This adapter board with dimensions 47.5mm x 14.0mm fits in such Kato (USA) N-gauge locomotives that have a wide body design such as F-units. It replaces the original circuit board and has connection...

The E24 adapter board is suitable if you want to digitize a very small locomotive without a digital interface using the LokSound 5 Nano. With dimensions of only 19.6 mm x 8.5 mm, the board is exactly...

With the help of the BLI Paragon 3/4 (P34) adapter board, H0 Scale tender steam locomotives from Broadway Limited (BLI), in which a Paragon 3 or Paragon 4 decoder was factory installed, can finally...

This adapter board is for owners of a Hübner railbus in track 1 (Art. No. 4070 or 4071) thought. There, a LokSound 2 decoder was installed in the motor car on a special adapter, and in the...

This adapter board ensures the convenient connection of your LokSound 5 L or LokPilot 5 L Decoders. The decoder is inserted directly into the socket strips. On the output side, the most important...

If necessary, you can add the Decoder Tester Extension to your Profi Decoder Tester: Plugged into the side of the Decoder Tester it enables you to comfortably test all large scale decoders. If you...

The Next18 adapter board is suitable if you want to digitize a very small locomotive without a digital interface, but do not want to freely wire the decoder. With dimensions of only 13.0 mm x 9.0 mm,...

Adapter board, 18-pin Next-18 socket to Plux16.

Adapter board, 18-pin Next-18 socket to NEM652 8-pin, Flex, 88mm, with heat shrink tube.