Description
The Decoder Buddy V5 and V5B were developed for the 12 output decoders and include a couple added features. This mother board does not include the 21-Pin Decoder. This mother board requires soldering. This printed circuit board is NOT INTENDED FOR USE IN A DC SYSTEM. However, if the decoder you are using supports DC operation it should work.The V5 and V5B come with standard 2.2K resistors onboard. One 21 Pin Decoder receptacle
- Two pairs of track input pads
- One pair of motor input pads
- One set of stay alive pads (U+, GND on the V5. The V5B has the “W” pad for a Power Pack)
- Two pairs of speaker pads in parallel by side
- 12 lighting outputs on a separable “small connector board”
- Lighting outputs A11 and A12 are replicated on the “motherboard”
Resistors for use with LED lighting. The “0” ohm resistors accommodate previously installed LEDs with resistors in line and “12-volt LEDs”. It is IMPORTANT to realize that resistors must be used when LEDs are connected to the lighting outputs of the custom “0” Ohm boards!!!
Details
Store Location: |
P# 225 / Aisle 14B #4410 |
Customer Reviews
-
Great customer...
Very helpful customer service
-
Makes decoder installs...
This simplifies decoder installation.
