RR-CirKits, Inc

Servo Connection Cable (M-M) This 4" cable may be used to connect two Quik-Link devices.

(Block Occupancy Detector-4)  This board operates as a DCC occupancy detector for 4 blocks using remote CT coils. It outputs logic levels, and has a RR-CirKits standard ribbon connector...

15V DC Power Adapter (1500mA Output, 100-240V AC Input) This high quality regulated switching power adapter powers any 15 Volt DC device up to 1.5 Amp. Made with quality in mind, this unit...

Logic level interface compatible with other standard RR-CirKits I/O modules. Boot Loader for user installable firmware upgrades. Includes powerful internal Logic Elements. Also compatible with JMRI...

May be used to provide the required termination at each end of the CAN bus LCC®  Balanced CAN termination provides the best noise rejection. Includes CAN bus Power Indicator and CAN bus data monitor...

Bit level repeater connects two LCC ® CAN bus segments. Quad RJ45 connectors for dual LCC ® CAN bus loop through connections. Includes a CAN bus data monitor LED for network trouble shooting. 2 LED...

Create a powered LCC bus for simple wiring by powering your LCC Nodes over the cable. The LCC Power-Point supplies 1/2A to each LCC CAN Bus cable.  PS-S-15-1200 universal switching power...

Multiple Terminal Block Push-in Wiring Cable connector Quick Cable connector, 2 in, 6 out. No more soldering under the layout. Fits AWG 28 - AWG 12 so there is no problem connecting different wire...

Servo Extension Cable (M-F) This 39" cable may be used to extend the length of the above (M-M) cables.

Servo Connection Cable (M-M) This 20" cable may be used to connect two Quik-Link devices.

This Breakout board allows easy solder free connections from up to 8 Quik-Link devices to 10 pin I/O cables using 3 wire servo style cables. Also compatible with Berrett Hill products.

The TAB is designed to provide a solder-less connection between the SMD-8 and Tortoise. It includes 10 pin daisy chain cable headers and channel selection jumpers. Breakaway connector inserts allow...

The Button-QL is an LCC Sample Mode compatible indicator/switch unit. When used with an LCC node the switch function and indicator function may be controlled separately over the same I/O channel. The...

The Tortoise Quik-Link is a plug on Tortoise driver board. Breakaway connector inserts allow use on older Tortoises with narrow paddle contacts. It connects directly to any LCC output port with a...

This plastic mounting track is suitable for mounting six I/O modules to a flat surface. (3 1/2" x 12")

This plastic mounting track is suitable for mounting four I/O modules to a flat surface. (3 1/2" x 8")

This plastic mounting track is suitable for mounting three I/O modules to a flat surface. (3 1/2" x 6")

This plastic mounting track is suitable for mounting two I/O modules to a flat surface. (3 1/2" x 4")

This plastic mounting track is suitable for mounting a single I/O module to a flat surface. (3 1/2" x 2")

(10 position IDC male with latch) Box of 10 Insulation Displacement Connectors for use with 10 wire flat ribbon cable. Use with IDC-S10 to create extension cables. Screw ears allow easy mounting to...