Whistle Stop Models N6508 - 2 Cell Towers - N Scale

This is a set of (2) cell towers.
One tower includes a base station created form a 20 ft container with electric meter and disconnect on it.
The towers are assembled in pieces and one can be made taller while the other is made smaller, as shown they are about 9″ tall.

When assembling if they do not slip together easy, use a hobby knife (xacto knife) to clean out the holes.
Inside the hole, as they are so small, there could be a tiny amount of uncured resin. If the knife blade has resin on it after cleaning out the whole just clean it off with a paper towel and throw away, it is such a minor amount that it is not a concern.

These are 3D resin printed, high detail models. But as resin is delicate, if they do break all you have to do is use thick super glue to put them together again – but I’m sure you already know that being an hobbiest like you are!
These may come on printing sprues, shipping sprues, or already apart.
To help remove printing sprus wash part under hot water to warm it up.
The sprues are the smallest connecting points on the model and will break off easy, especially when warmed up.
These are not painted.