DCC Accessories

The Decoder Buddy V5 and V5B were developed for the 12 output decoders and include a couple added features. This mother board does not include the 21-Pin Decoder. This mother board requires soldering...

Build your control panels with greatly simplified wiring. Just connect push buttons to the Mini Panel and use to issue turnout routing macros, individual turnout commands by pushing one button. Set...

The AR10 is an automatic reverse loop controller for DCC layouts. It requires just 4 connections, two to the main line and two to the loop. In addition it functions as a circuit breaker for the...

Same six-wire connectors in front as UTP but allows use of off-the-shelf CAT5 cables to connect panel-to-panel at rear. Can be used as a cab bus splitter and also adds the ability to add power to the...

Add this USB computer interface for computer programming and/or operation of your Power Cab equipped layout. Requires USB cable, computer and railroad computer program such as JMRI Decoder Pro and...

Provides short circuit protection for one power district. Can be used with most DCC systems. Default trip time is 30 times faster compared to the basic overload setting in all NCE systems. Electronic...

13.8v DC Power Supply. 1.3 Amp / 2 amp peak. US approved power supply suitable for PowerCab and other applications. This plugs into the back of panels such as the PCP(PowerCab connection panel) and...

Add a separate PCP panel to operate your PowerCab in other places or on other layouts. Use the P114 and you will only have to move the PowerCab.

The Auxiliary Input Unit (AIU) provides a means of connecting external devices such as switch contacts, Block Detectors (BD20), or other sensors to the NCE Cab Bus or Command Station. These external...

Detects DCC current being drawn in a block. Connects to AIU01 or Mini Panel. Isolated so that there is no electrical connection to the track. Needs no external power for most operations, suitable for...

This is our lowest cost, easiest to use cab bus panel. All four RJ-12 jacks are wired in parallel for easy plug and play use. This board also provides a convenient point to add additional 12 Volt cab...

Your Kato Unitrack and LGB remote control turnouts can now be DCC controlled. The Switch-Kat provides connections for optional switch position indicator lights and "local control" pushbuttons. Simple...

All new easy programming with no jumpers. Features: On board display Control for 8 Tortoise switch machines Remembers the position of switch during power outages Supports the full range of...

Engineer cab with LED display uses a more conventional potentiometer knob for speed control. Definite stop and starting points.  Clear, easy-to-read display, select up to 6 loco recalls, F0-F28,...

Engineer cab with LED display uses a more conventional potentiometer knob for speed control. Definite stop and starting points. Note** the speed setting of the knob is instantly applied to any...

The Cab06 uses a more conventional knob for speed control. The Cab06 can be set to YARD mode. Yard mode makes the speed knob act as a "center off" speed control. Turn the knob to the right and the...

Deluxe cab provides user-friendly access to advanced system features. Backlit LCD displays guide you through operations easily. Both a thumb wheel knob and repeating push buttons for speed control...

Our deluxe Radio Equipped Pro Cab R provides the most user-friendly access to all system features. Uncomplicated menus on the easy to read, backlit LCD display guide you through the most advanced...

Requires an MRC Prodigy Express2 or Prodigy Advance2 system. Works With ANY Brand Loco or DCC Decoder. Plug-N-Play Setup and Operation. Module acts as an interface between the two most popular...

Decoder tester (Replaces 51900), NEM651, NEM652, 21MTC, PluX22, Next18, single wires. With motor, LED-Monitor and 20mm speaker. New socket to accept decoder tester extension 53901Â Perhaps you are...