ESU

Adapter board, 18-pin Next-18 socket to NEM651 6-pin, Flex, 88mm, with heat shrink tube

Wire harness, 18-pin Next18 socket to open wires, 88mm, with heat shrink tube

This adapter board can be connected to all decoders with an E24 connection and offers a PluX16 interface on the locomotive side. This means, for example, a LokSound 5 Nano or LokPilot 5 Nano can be...

For professionals in digital model railroading there is a new adapter board. This makes installation easier and safer. First all wires are connected to the soldering points of the adapter board. All...

With this expansion board you can easily expand your LokPilot or LokSound decoder (with 21MTC interface!): All you need to do is to plug the decoder onto the expansion board and benefit...

The 21 MTC adapter board 2 is also suitable for digitising a loco without interface. It is very helpful, if you do not intend to wire the decoder freely or if you wish to use more than four function...

The 21 MTC adapter board is suitable for digitising a loco without interface and for the case you do not intend to wire the decoder freely. The adapter board offers a possibility for installing a...

Many railcars are equipped with a grinder at both ends. For proper function in block locations and for timely stopping in front of red signals, it is essential that depending on the direction of...

For the retrofit of old Märklin all-current motors you need a permanent magnet. It replaces the present field  winding, and in combination with a LokSound – or LokPilot decoder, helps...

For the retrofit of old Märklin all-current motors you need a permanent magnet. It replaces the present field  winding, and in combination with a LokSound – or LokPilot decoder, helps...

For the retrofit of old Märklin all-current motors you need a permanent magnet. It replaces the present field  winding, and in combination with a LokSound – or LokPilot decoder, helps...

For the retrofit of old Märklin all-current motors you need a permanent magnet. It replaces the present field  winding, and in combination with a LokSound – or LokPilot decoder, helps...

This adapter board provides the suitable connections for your new LokSound/LokPilot L decoder. The decoder can be plugged directly into the socket terminal strip. All functions of the locomotive can...

Our new adapter board 3 for decoders with PluX22 interface is best suited for everyone intending to digitise a loco without interface but with many functions without having to carry out major...

Our new adapter board 3 for decoders with 21MTC interface is best suited for everyone intending to digitise a loco without interface but with many functions without having to carry out major...

On request, this dummy plug replaces a LokSound 5 L or LokSound L V4.0 decoder in locomotives that are to run on analog systems. The dummy plug is plugged onto the Adat board 51959. DIP switches can...

Perfect for Athearn (and others) this new 9 pin (female) 21MTC (Male) adaptor board allows the popular 6 output ESU 21 MTC LokSound and LokPilot decoders to be easily added to your favorite...

With the Servo Extension Cable you are able to lengthen your Precision Servo Motor by up to 75cm.

Our SwitchPilot decoders cannot only control point mechanisms but also daylight signals. Most modern signals are equipped with LEDs. Usually the anode connections of multi-aspect signals are combined...

These adaptor boards greatly simplify set-up and wiring of ABC braking sections. They are simply plugged into the terminals of a SwitchPilot Extension. Every adaptor board can generate the signals...